URC6430, URC6440: How do I program my code on my Simple remote?

To program the basic code on your Simple remote, please follow the instructions mentioned below:

  1. Hold down the Setup key until the light blinks once and then twice.
  2. Press the relevant device key.
  3. Enter the code, the light blinks twice.
  4. You can now operate your device.

If the LED does not blink twice at the end, please try the following:

  1. Hold the Setup key down until the light blinks twice.
  2. Press 992, the light blinks twice.
  3. Press the device key twice, the light will blink twice.
  4. You can now set up the device code.